Skip to content

Matrix-II-Net

General Info

Reader MATRIX-II Net is designed to manage access in accommodation and production facilities, track of passage time and events. Reader can operate both in standalone mode and using the network. Connection and operation in standalone mode of reader MATRIX-II Net are the same as for reader MATRIX-II K. Connection to network by RS 485 (double-wire connection). Reader MATRIX-II Net allows connection of the following equipment: - non-contact reader for proximity-cards, emulating TM key protocol (recommended reader MATRIX-II);

  • electromagnetic lock, electromechanical lock/latch;
  • door release button (normally open);
  • external buzzer, external light-emitting diode (analogue set at the controller plate);
  • open door sensor (normally open type).

Specifications

Connection element of lock type (electromagnetic/electromechanical)

Light and sound indication of operating and programming modes

Setup of lock release duration: from 0 to 220 sec (factory default - 3 sec)

Output: MIS-transistor

Operating voltage: 12V DC

Useful current (standby mode) 30mA

Communication current up to 5А Ambient temperature: from -30С to +50С Relative air humidity: not exceeding 90%

Characteristics for off-line operation (without network connection)

Maximum number of keys: - up to 2024 pcs.

  • simple cards for passage
  • master cards to enter into programming modes and turn off “Lock” mode
  • Locking cards passage and turn on of "Lock" mode. Additional operating modes:
  • "Lock” mode –passage is open for locking keys and closed for simple cards;
  • "Accept" mode – passage is open, automatic record of all new cards into memory (turns on with master card).

Reader Operation

Install the reader at flat surface in a place providing free swipe of PROXIMITY cards. To install reader MATRIX-II proceed as follows:

  • Mark and drill holes corresponding to the reader holes

  • Connect the wires of required devices to reader connectors according to diagram. If the lock is electromechanical install connection element into position 1.

  • Depending on the side of reader cable laying remove thin connecting strip in the reader body frame and lay the cable into the body. When the power is supplied to the reader red diode turns on and the reader enters into programming mode (first switching – record of master cards).
  • Install the reader and fix it with screws. Close the holes on the reader with supplied protective caps. *if you install two reader at a distance not closer than 10 cm, actuation range may reduce. Distance between reader should not be less than 3 cm.